How to Install a Glass Balustrade on Decking

A glass balustrade is a realistic DIY job for a competent person with a helper. The secret is a solid fixing for every post and a careful, patient approach to the glass. Here is how we recommend doing it.

Tools and materials

  • Posts and glass panels sized for your run (see our measuring guide)
  • M10 × 100mm coach screws for timber, or anchor bolts for concrete
  • Drill, socket set, spirit level, tape, string line
  • Rubber packers or offcuts to support the glass while fitting
  • A second person. Glass panels are heavy (10mm glass weighs about 25kg per square metre).

1. Check the structure first

Posts must be fixed into solid joists, never into decking boards alone. Lift boards if you need to find joists, and add noggins (short timber blocks) between joists where a post lands between them. A balustrade is only as strong as what it is fixed to.

2. Set out the post positions

Run a string line along the edge. Mark the post centres from your layout, remembering each post takes 85mm of the run. Check the spacing twice. The glass cannot be cut to correct a mistake.

3. Fix the end posts, then the rest

  1. Fix the two end posts first, through every hole in the base plate.
  2. Check each is plumb in both directions before final tightening.
  3. Run a string between the tops of the end posts and fix the centre and corner posts to that line.

4. Fit the glass

  1. Loosen the clamps on both posts.
  2. With a helper, lift the panel in and rest it on packers so the bottom edge sits about 100mm above the deck.
  3. Centre the panel so there is a small gap (at least 3mm) between the glass edge and every clamp. Glass must never touch metal.
  4. Tighten the clamps by hand with a hex key, a little at a time on each. Never use power tools: over-tightening can stress and shatter toughened glass.
  5. Remove the packers and check the line.

5. Fit the handrail (handrail system only)

Seat the spigots on the post tops, cut the 42.4mm rail to length with a fine-tooth blade, and join lengths with connectors and elbows at corners. Finish exposed ends with end caps or a wall connector.

6. Final checks and care

  • Re-check every clamp once all panels are in.
  • Push firmly along the top. Nothing should move at the base plates.
  • Clean the 316 stainless now and then with warm soapy water, especially near the coast.

Mistakes to avoid

  • Screwing posts into boards rather than joists
  • Using power tools on the clamps
  • Letting glass sit directly on the deck or touch a post
  • Skipping the plumb check on the first posts

Get your layout priced in two minutes

Enter your run lengths into our free glass balustrade designer and it works out the panel widths, posts and fittings for you, with an instant price including VAT and free delivery to UK mainland. Prefer a hand-checked plan? Our layout planning pack includes a consultation with our team.

Building regulations vary with the project. This guide is general information, not design advice. Always confirm your plans with your local building control body before you order.

Back to blog