How to Measure for a Glass Balustrade: Posts, Panels and Gaps

Toughened glass cannot be cut once it is made, so the single most important job on a glass balustrade project is measuring properly. The good news: with stock panel sizes and a simple formula, you can plan almost any straight or cornered run yourself in a few minutes.

What you need before you start

  • A steel tape measure (a laser measure is even better for long runs)
  • Pencil and paper, or our printable layout sheets
  • Knowledge of what you are fixing into: concrete, brick, or timber joists

Step 1: Measure the full run

Measure the total length of each straight section, wall to wall or end to end, along the line where the posts will sit. Measure at both ends and the middle; walls are rarely perfectly square, so use the smallest figure. Note each section separately if your balustrade turns a corner.

Step 2: Understand how much room each post takes

In our systems, every post takes up 85mm of the run. That gives a simple formula:

Total run = (number of posts × 85mm) + (combined width of your glass panels)

Panels come in 13 stock widths from 300mm to 1500mm in 100mm steps, so you choose a mix of widths that fills the space without any custom glass.

Step 3: Choose your post types

  • End posts start and finish a run (two clamps)
  • Centre posts sit between two panels on a straight (four clamps)
  • Corner posts turn a 90° corner (four clamps)
  • Angle posts handle non-standard angles

Posts arrive with the correct clamps already fitted. If you would rather fix the glass to a wall at one end, a wall-mounted clamp can replace an end post, though we recommend a post at every termination where possible.

Step 4: A worked example

Say you have a straight 4,000mm run of decking.

  1. Try four panels: that needs five posts (two end, three centre). Posts use 5 × 85 = 425mm.
  2. Space left for glass: 4,000 − 425 = 3,575mm.
  3. Divide between four panels: about 894mm each. Round down to stock sizes: three panels at 900mm and one at 800mm = 3,500mm.
  4. That leaves 75mm spare, which is taken up in the small gaps at each clamp and post. Perfect.

Aim for evenly sized panels where you can; it looks better and keeps post spacing regular. Keep spacing sensible for the structure. Long panels on a lightweight deck put more load on each post.

Step 5: Allow for the gaps

  • At the clamps: leave a small expansion gap between the glass edge and the metal (a minimum of 3mm) so the glass never touches steel.
  • At the base: design in a gap of about 100mm under the glass for drainage and cleaning.

Step 6: Check what you are fixing into

Posts must be fixed into something solid. Use M10 × 100mm anchor bolts for concrete and brickwork, or M10 × 100mm coach screws into timber joists, never decking boards alone. Fix through every hole in the base plate.

Common measuring mistakes

  • Forgetting the 85mm per post, so the panels do not fit
  • Measuring at one point only on an out-of-square wall
  • Planning post positions where there is no joist underneath
  • Ordering odd panel sizes when two equal panels would look better

Get your layout priced in two minutes

Enter your run lengths into our free glass balustrade designer and it works out the panel widths, posts and fittings for you, with an instant price including VAT and free delivery to UK mainland. Prefer a hand-checked plan? Our layout planning pack includes a consultation with our team.

Building regulations vary with the project. This guide is general information, not design advice. Always confirm your plans with your local building control body before you order.

Back to blog