Fittings & Accessories

<p>Fittings, fixings and spares for glass balustrade installations, in <strong>316 marine grade stainless steel</strong> where the part is exposed to weather.</p>

<h3>Glass clamps</h3>
<p>Square back clamps sit flush against flat-faced posts and walls; curved back clamps are shaped to fit round tube. Both hold <strong>10mm toughened glass</strong> and are supplied with rubber inserts. Posts already arrive with the correct number of clamps, so these are for <strong>replacements, spares or non-standard runs</strong>.</p>

<h3>Gate hardware</h3>
<p>Self-closing hinges return a glass gate to the closed position without a separate closer, with a matching latch to suit. Both <strong>clamp directly onto the glass with no drilling required</strong>, which keeps the panel at full strength.</p>

<h3>Post fixings</h3>
<p>M10 x 100mm anchor bolts for concrete and brickwork, and hexagon head coach screws for timber decking and joists, both in packs of ten. Sized to reach the <strong>minimum 100mm fixing depth</strong> recommended for balustrade base plates. A 7mm drill bit and 8mm tap set is available for on-site fabrication of angle post fixings.</p>

<p><strong>A note on fitting:</strong> never tighten glass clamps with power tools, and leave a minimum 3mm gap between the glass edge and the clamp to allow for expansion.</p>