Flat Roof Skylight Sizes: How to Measure Your Opening

Getting the size right is the most important part of buying a flat roof skylight. Rooflights are sold by the opening they sit over, and the unit is built to overhang that opening. Here is how to measure without second-guessing.

The golden rule: order to the structural opening

Our triple glazed flat roof skylights are sized to the structural opening: the internal face-to-face size of the hole you build the upstand (kerb) around. Do not add anything for the kerb or the overhang. That is already built into the unit.

How to measure

  1. Measure the opening between the inside faces of the upstand, in both directions.
  2. Measure at both ends and the middle; use the smallest figure.
  3. Match it to a stock size. We offer 17 sizes from 300 × 300mm up to 1000 × 1500mm.

New opening? Choose the size first

If you are building a new roof or extension, pick a stock skylight size first and frame the opening to suit. It is far easier than finding a skylight for an odd-sized hole, and it avoids waiting on a made-to-measure order.

Build the upstand

The skylight is supplied as the glazed unit only; no kerb is included. You build a timber upstand and batten on site to form the rebate the glazing sits into. Our free installation guide gives the exact upstand and batten dimensions.

Allow for the fall

The skylight must be installed to a fall of at least 40mm per 1000mm of run so rain runs off rather than pooling. Plan the fall into the roof or upstand from the start.

Why triple glazed?

  • Three toughened panes with Low-E coatings and two argon-filled cavities
  • A centre-pane U-value of 0.8 W/m²K, keeping heat in during winter
  • Fixed (non-opening) for a clean sightline and fewer points of failure

Quick checklist

  • Measured inside faces of the upstand, smallest figure
  • Matched to a stock size, nothing added
  • Fall of 40mm per metre planned
  • Building control checked for structure and upstand height

See all sizes and prices on our flat roof skylight page. Delivery is by specialist freight to mainland UK addresses.

Building regulations vary with the project. This guide is general information, not design advice. Always confirm your plans with your local building control body before you order.

Back to blog